Land Rover Series III 88" Stage 1 V8 Petrol

This is the cheapest and easiest way into Land Rovers.  Choose an early 1980s model, with five-bearing crankshaft and strong gearbox.

Dimensions 88 inch H1980mm; W1680mm; L3620mm

Max Load Capacity 704-1095kg  Insurance Group 5-6

Little changed cosmetically between the IIA and the Series III. The Series III is the most common Series vehicle, with 440,000 of the type built from 1971 to 1985. The headlights were moved to the wings on late production IIA models from 1968/9 onward (ostensibly to comply with Australian, American and Dutch lighting regulations) and remained in this position for the Series III. The traditional metal grille, featured on the Series I, II and IIA, was replaced with a plastic one for the Series III model. The 2.25 L engine had its compression raised from 7:1 to 8:1, increasing the power slightly (the high compression engine had been an optional fit on the IIa model for several years). During the Series III production run from 1971 until 1985, the 1,000,000th Land Rover rolled off the production line in 1976. The Series III saw many changes in the later part of its life as Land Rover updated the design to meet increased competition. This was the first model to feature synchromesh on all four gears, although some late H suffix IIa models had used an all-synchro box. In keeping with early 1970s trends in automotive interior design, both in safety and use of more advanced materials, the simple metal dashboard of earlier models was redesigned to accept a new moulded plastic dash. The instrument cluster, which was previously centrally located, was moved to the driver's side. The Series III had the same body and engine options as the preceding IIa, including station wagons and One Ton versions. 

From 1979 the more powerful 3.5-litre V8 petrol engine as used in the Range Rover, albeit a detuned version (91 horsepower), was used in the Stage 1 V8 109. This was the first stage in the development of what was to become the 110. It used a variant of the Range Rover engine and drive train making it the only Series III vehicle to have permanent four wheel drive.

In 1980 the 4-cylinder 2.25-litre engines (both petrol and diesel) were updated with five-bearing crankshafts to increase strength in heavy duty work. At the same time the transmission, axles and wheel hubs were re-designed for increased strength. This was the culmination of a series of updates to the transmission that had been made since the 1960s to combat the all-too-common problem of the rear axle half-shafts breaking in heavy usage. This problem was partly due to the design of the shafts themselves. Due to the fully-floating design of the rear wheel hubs, the half shafts can be removed very quickly without even having to jack the vehicle off the ground. Rover designed the shafts to have a weak point so if the transmission was over-stressed, the easily-replaced half-shafts would break instead of a differential unit or the main gearbox. The tendency for commercial operators to overload their vehicles exacerbated this intended flaw which blighted the Series Land Rovers in many of their export markets and established a reputation that continues in many markets to the present day. This is despite the 1982 re-design (mainly the changing of the driveshafts from 12 driving-splines to 24 to reduce stress) all but solved the problem.

These changes culminated in 1982 with the introduction of the "County" spec Station Wagon Land Rovers, available in both 88-inch and 109-inch types. These had all-new cloth seats from the Leyland T-45 Lorry, soundproofing kits, tinted glass and other "soft" options designed to appeal to the leisure owner/user.

Of more interest was the introduction of the High Capacity Pick Up to the 109-inch chassis. This was a pick-up truck load bay that offered 25% more cubic capacity than the standard pick-up style.